International Journal of Power Electronics and Drive Systems
Papers 104
1 page of 11 pages (104 results)
#1Nur Ashida Salim (UiTM: Universiti Teknologi MARA)H-Index: 5
#2Nur Diyana Shahirah Mohd Zain (UiTM: Universiti Teknologi MARA)
Last. Nur Fadilah Ab Aziz (TNB: Universiti Tenaga Nasional)H-Index: 1
view all 5 authors...
Transient stability in power system is vital to be addressed due to large disturbances that could damage the system such as load changes and voltage increases. This paper presents a multi-machine transient stability using the Static Synchronous Series Compensator (SSSC). SSSC is a device that is connected in series with the power transmission line and produces controllable voltage which contribute to a better performance in the power system stability. As a result, this research has observed a co...
#1C. L. Toh (TNB: Universiti Tenaga Nasional)H-Index: 6
#2Pei Cheng Ooi (University of Nottingham)
A recuperating converter is highly demanded in traction power substation to deliver the braking energy generated by a traction vehicle. Conventional voltage source inverter had been implemented in the traction power station. However, large ac line filters must be installed to improve the quality of ac voltages and currents. This paper proposes to install a nine-level Modular Multilevel Converter (MMC) as a recuperating converter. The main aim is to eliminate the need of ac line filters while pro...
The existing mixer grinder comprises of the universal motor operating in alternating current supply due to high starting torque characteristics and simple controlling of the speed. The absence of brushes and the reduction of noise in the Brushless DC (BLDC) extends its lifetime and makes it ideal in a mixer grinder. A novel solar-powered BLDC motor drive for mixer grinder is presented in this paper. A DC-DC boost converter has been utilised to operate a PV (photovoltaic) array at its highest pow...
#1N S Jayalakshmi (Manipal University)
#2D. N. Gaonkar (KREC: National Institute of Technology, Karnataka)
Last. Sanchit Kumar Jain (Manipal University)
view all 3 authors...
The output of the PMSG based wind energy conversion system (WECS) is fluctuating in nature due to intermittency of wind speed. The distribution static synchronous compensator (DSTATCOM) incorporated with the battery energy storage system (BESS) is used to smooth the power produced from wind generator system. The control strategy of BESS/DSTATCOM and its integration to mitigate the power fluctuations of grid connected WECS is presented. Three-leg three-phase voltage source converter (VSC) based D...
#1Ahmad Fudholi (UKM: National University of Malaysia)H-Index: 18
#2Mariyam Fazleena Musthafa (UKM: National University of Malaysia)H-Index: 2
Last. Mohd. Yusof Othman (UKM: National University of Malaysia)H-Index: 26
view all 6 authors...
Solar energy is renewable and environment friendly and has been widely used in electricity generation and thermal energy through photovoltaic thermal (PVT) system. This system is beneficial in terms of maximum energy generation and cost of usage. The growing concern on energy sources and their usage has increased the significance and demand for PVT collectors. A PVT air collector consists of a PV panel and a thermal collector system. In PVT air collector, electricity and thermal energy are gener...
#1Arvind Raj (TNB: Universiti Tenaga Nasional)
#2Nur Fadilah Ab Aziz (TNB: Universiti Tenaga Nasional)H-Index: 1
Last. Nur Ashida Salim (UiTM: Universiti Teknologi MARA)H-Index: 5
view all 4 authors...
Voltage instability in power distribution systems can result in voltage collapse throughout the grid. Today, with the advanced of power generation technology from renewable sources, concerns of utility companies are much being focused on the stability of the grid when there is an integration of distributed generation (DG) in the system. This paper presents a study on DG units placement and sizing in a radial distribution network by using a pre-developed index called Voltage Stability Condition I...
#1Nurul Shahirah Binti Rukman (UKM: National University of Malaysia)H-Index: 2
#2Ahmad Fudholi (UKM: National University of Malaysia)H-Index: 18
Last. K. Sopian (UKM: National University of Malaysia)H-Index: 6
view all 7 authors...
Conventional fuels are not free, scarce and expensive, and its future cost and availability are uncertain. Hence, the usage of solar energy in applications will probably increase and further become economically feasible in the near future. Solar energy is free, clean, and renewable and has been widely used in electricity generation and thermal energy via photovoltaic thermal (PVT) system. PVT is a hybrid system consists of a PV panel and a solar collector in a single unit to simultaneously produ...
2 CitationsSource
#1Ahmed Mohamed Omer Abdulmula (UKM: National University of Malaysia)H-Index: 1
#2K. SopianH-Index: 6
view all 4 authors...
This paper is performed to investigate the performance of ‎dual-axis solar tracking system with maximum light detection for off-grid telecommunication towers under weather conditions in Malaysia. The studied system consists of High-efficiency heterojunction intrinsic thin (HIT) film solar modules ‎coupled with state-of-the-art dual-axis maximum light detection (MLD) solar ‎tracking system. The ‎investigation method is based on the analyzed the daily actual data record for both the average power ...
1 CitationsSource
#1Sarun Soman (MIT: Manipal Institute of Technology)H-Index: 1
#2Nishtha Shelly (MIT: Manipal Institute of Technology)
Last. Sudheer T S Kumar (MIT: Manipal Institute of Technology)
view all 4 authors...
Switching Power Converters convert one form of power to another with high ef-ciency and accurate control.One of the most widely used DC-DC Converter is Buck Converter. Control is invariably required to maintain the output voltage/current in spite of variations in source/load. In order to design the controller and gain insight about the system a dynamic model needs to be developed. Modeling techniques widely used are state space averaging and PWM switch model. In this paper DC transformer modelin...
#1Shwetha Dv (MIT: Manipal Institute of Technology)
#2Lakshman Rao S. Paragond (MIT: Manipal Institute of Technology)H-Index: 1
This paper recounts the design and construction of various controlling techniques for buck converter. If the designed controller for any converter is not proper which leads to high overshoot and steady state error, and its dynamic response varies with changes in load, especially at high load current conditions. The lead-lag controller for the converter is desgined using classical control theory ,Bode Plot technique is used to examine the stability of the system.By using deravetive part of the PI...
Top fields of study
Control engineering
Photovoltaic system
Control theory
Control theory