Match!
Amit Kumar
Thapar University
Fuzzy set operationsFuzzy numberFuzzy logicMedicineBiology
1,059Publications
27H-index
3,971Citations
What is this?
Publications 578
Newest
#1Himanshu MauryaH-Index: 2
#2Amit KumarH-Index: 27
Last. Rajib Kumar PanigrahiH-Index: 2
view all 4 authors...
Source
#1Uttam Kumar DasH-Index: 8
#2Trevor JanesH-Index: 3
Last. David MilsteinH-Index: 73
view all 4 authors...
Herein we report the selective hydrogenation of cyclic imides to diols and amines, homogeneously catalyzed for the first time by a complex of an earth-abundant metal, a manganese pincer complex. A plausible catalytic cycle is proposed based on informative mechanistic experiments.
Source
#1Amit KumarH-Index: 27
#2Amit GuptaH-Index: 23
Last. Sanjeev KumarH-Index: 16
view all 5 authors...
The purpose of the study was to compare 2 techniques of arthrocentesis, to find out the efficacy of one over the other at various parameters, and to contribute to the scarce literature of these 2 t...
Source
#1Ramesh KumarH-Index: 27
#2Malik Zainul Abdin (Hamdard University)H-Index: 31
Last. Amit KumarH-Index: 27
view all 5 authors...
Culture conditions were optimized for high-frequency plant regulation via zygotic embryogenesis from cell culture of Euryale ferox (Makhana). Zygotic embryo developed into the yellowish globular structure and small callus followed by shoot formation at a frequency of 40%. When cultured on half-strength Murashige and Skoog (MS) medium, supplemented with 0, 0.1, 0.3, 0.5, 1.0, 1.5 mg/L of 2,4-D as growth regulator, the frequency of yellowish globular structure increased flabbily.
A Welding technique is defined as the process of joining two different or same metals by fusion process, with or without application of pressure and with or without use of filler metal. Welding of different or same material are depends upon various factors like the metallurgical changes, chemical changes , physical changes that occur due to welding, change in hardness of material, in and around the welding bed and the extent of wear and tear or we can say cracking tendency of the joint. Welding ...
#2Amit KumarH-Index: 2
Last. Ajar Nath YadavH-Index: 20
view all 5 authors...
Source
#2Himadri Chattopadhyay (Jadavpur University)H-Index: 22
Last. Amit KumarH-Index: 27
view all 3 authors...
Abstract Present study aims at producing silicon carbide particles (0, 3, 5 and 7 wt%) reinforced aluminium-copper based composites via stir casting route. The forging behavior of developed composites was studied by deforming the stir cast samples. Optical microscopy, Scanning electron microscopy with Energy dispersive spectroscopy and X-ray diffraction techniques were used to study the metallurgical changes in as cast and deformed samples. Microhardness and tensile strength of fabricated compos...
Source
#1Kameshwar PrasadH-Index: 30
#2Pradeep KumarH-Index: 23
view all 7 authors...
Source
Source
12345678910